Saber x Rin Flag


One-sided print with 2 top grommets

☆ Approximately 3.6′ x 5′ (ft)

☆ Artwork by UNAGIMARU

Please check out our FAQ/terms here for wait times. Don’t see an answer to your question? Feel free to contact us.

Flag pre-orders:  3-6 weeks to manufacture and process.

Processing time for in-stock: 2-8 business days (no weekends) 

Purchasing any items means you have read and understand the FAQ/terms.

Ironing tips:

  1. Lay the flag flat.
  2. Plug your iron in, turn it on and set it to the warm setting. Allow it to heat up.
  3. Place a thin cloth or towel over the flag to protect the polyester from direct heat. Iron over this cloth rather directly onto the flag.
  4. Iron the flag until the wrinkles are gone. Start from the top of the flag and work your way down, going width ways.
  5. Once you’ve finished ironing a section, let it cool and then move the flag along the board to iron the next section.
  6. If the wrinkles are stubborn, use steam or spray the fabric with water before ironing over it again.
  7. Hang the flag up immediately to let gravity pull out extra wrinkles.

Out of stock

Shopping Cart